R216 Rotary Disc Header Quick Card
Windrow Forming Guidelines
Windrow Width
Rear
Ba
ffl
e
Posi on
Forming Shield
3–5 . (0.9–1.5 m) Up
Does all windrow forma on. Adjust sides to desired width
5–7 . (1.5–2.1 m) Mid
Par al windrow forma on. Adjust sides and ba
ffl
e
7–8 . (2.1–2.4 m) Down
Not in use
DWA
2nd notch
from top
Set at highest se ng which does not interfere with DWA
Standard Header Se ngs
Disc speed
2100 rpm
Header height
0
–
1
Header lt
3
–
4
Adjust to change cut height, use
skid shoes for high cut heights.
Ground speed
Adjust un l condi oning
performance is a
ff
ected.
Use this card as a guide only. Refer to your operator’s manual for detailed se ngs and adjustment procedures.
Adjus ng the Windrow
Rear Ba
ffl
e Posi on (Manual)
Rear Ba
ffl
e Posi on (Electronic)
–
Op onal
Controls windrow height/width. Directs crop
fl
ow that a
ff
ects width.
1.
Remove lynch pin (B).
2.
Pull lever (A) inboard to disengage bracket (C):
•
Move lever forward (raise ba
ffl
e) for narrow swath.
•
Move lever backward (lower ba
ffl
e) for wide swath.
3.
Release lever so tab engages the notch in bracket (C).
4.
Secure lever with lynch pin (A).
The posi on of the rear ba
ffl
e can be adjusted from inside the cab.
1.
To adjust the ba
ffl
e up and down, press F5 (A) and F6 (B) keys
respec vely.
2.
A pop up will appear on the HPT display for 3 seconds indica ng the
ba
ffl
e posi on from 0
–
10.
Ba
ffl
e De
fl
ector Fins
Forming Shield
Control material distribu on across windrow.
1.
Remove
fi
ns from storage posi on (on top of ba
ffl
e).
2. Posi on de
fl
ector
fi
n (A) under ba
ffl
e.
3.
Secure with exis ng bolt and nut (B) (bolt head facing down).
4.
Adjust to approximately 60° angle inward.
5.
Torque nut to 69 Nm (51 lbf· ). Repeat on the other side.
NOTE:
In large stemmed crops or while using the DWA, remove
the
fi
ns and a ach them to the top of the ba
ffl
e for storage.
Controls windrow width and placement.
1.
Adjust forming shield using handle (B) under the windrower.
2.
To ensure windrow is centered, adjust both side de
fl
ectors (A) to the
same posi on.
