Panasonic KX-TVP150E, Overview

Page: 177 / 849

Manager’s Guide
System Administrator
M-3-29
3.3.5 Utility Command
In the utility command mode, the System Administrator can
access the functions described below by entering the
appropriate command (TIME, PASS, ONLN, OFLN, BREP,
PSET, ELOG, SAVE, LOAD or GPRN) at the $ prompt.
Set Time (TIME)
This command should be used to set the correct system
date and time to ensure accurate scheduling. A number of
functions require that the system time and date be set
correctly in order to operate properly. These include
message waiting notification, external message delivery,
call retries after initial failure to connect and automatic
deletion of messages.
System Backup
(SAVE, LOAD)
All system parameters, program, bulletin board messages
and voice prompts can be backed up in separate data files
on a data terminal connected to the RS-232C port of the
VPS. You cannot back up all of them at a time.
Once the data has been backed up, it can be restored to the
system’s hard disk in case of a disk crash or inadvertent
erasure by reversing the above process. The SAVE and
LOAD commands can be executed for each data file. It may
take much time to complete SAVE or LOAD for all the
data. When performing this operation please wait until the
end process indication appears.
The memory which is required for the data terminal to be
used for this feature:
1. Program — 400 kByte
2. Parameters — 0.5 kByte
3. System Prompts — approximately 5 MByte
4. User Prompts — depending upon the length of the
recorded messages.
5. Bulletin Messages — depending upon the length of the
recorded messages.