1.
Check the box
GSG unit
, then click
to configure the connection (for details, see
"Connecting StudioView to GSG" on page 122
.)
2.
Choose which data to record: Navigation data, Observations, RSG data, Satellites
data (e.g., satellite position, Doppler shift, etc), navigation messages.
Select
Output files
for each recorded data category.
3.
As an option, the NMEA data can also be
redirected
to a serial port e.g., to use it
with a device that utilizes real-time NMEA data (such as a marine plotter). If so
desired, select and configure the port to be used to redirect the data.
Preparing the Recording of Data Generated by a GNSS Receiver
On the
right side
of the screen:
1.
Select
Receiver
if you have a GNSS receiver connected to your StudioView com-
puter, and you want to record the life sky data it reads while e.g., driving a car
2.
Select and configure the
Serial port
(if in doubt, use the default settings)
3.
Select the type of
Receiver chip
: If you have a SiRF chip, StudioView will configure
this receiver automatically.
4.
Select an
Output file
for the recorded NMEA data that the receiver sees.
5.
If so desired, you can not only record the generated data, but also redirect it to a dif-
ferent
serial port
of your computer e.g., to consume the data with a third-party
application. If applicable, select and configure that port.
6.
As an option, the NMEA data can also be
redirected
to a GSG unit, in order to use it
with a device that utilizes real-time NMEA data (e.g., a marine plotter or receiver
demo software).
Note that GSG does not accept real-time NMEA data, only planned NMEA trajectory
data. When redirecting NMEA data to a GSG unit, StudioView actually converts the
NMEA data to RSG commands prior to sending the data.
To configure this feature, click
(for details, see
.)
7.
Select which data to send to the GSG unit. If the receiver does not send GGA data,
i.e. the data stream does not include any altitude information (as is the case with
RMC data), you may set a predefined altitude.
Recording the Data
Now, that the configuration is complete, click
and begin with your test drive.
Or, load the desired scenario on your GSG unit, and click
.
4.9 Studioview Tasks
User Manual GSG-5/6 Series Rev. 27
167
Summary of Contents for GSG-5 Series
Page 2: ......
Page 4: ...Blank page II User Manual GSG 5 6 Series...
Page 42: ...BLANK PAGE 2 5 Signal Power Level Considerations 26 User Manual GSG 5 6 Series Rev 27...
Page 382: ...BLANK PAGE 6 7 Revision History SCPI Guide 366 User Manual GSG 5 6 Series Rev 27...