Orolia GSG-5 Series, User Manual With Scpi Manual, Page: 173 / 392

Change multipath signal parameters
Change navigation message bits
Change signal propagation model.
To set the Time at which the event is to occur, specify the number of seconds from the
beginning of scenario.
Define a Target :
Scenario will apply the specified event to all satellites simulated in scenario.
Channel will apply the specified event to one of GSG's channels.
PRN
1
-x will apply the specified event to a particular GNSS satellite or SBAS; select a
PRN code number.
There are two Parameters types available for each event type - Absolute power or Relative
power - in next drop-down menu.
For Channel event, type Duplicate is also available.
Editing or Deleting an Event
To edit an event, highlight it, then double-click it, or click .
To delete an event highlight it, then click .
4.9.13.2 Adding a Jammer Signal in StudioView
It is possible to add a localized jamming signal to a scenario (or several of them), so as to
determine the response of a receiver-under-test to a jamming/interference condition.
1.
In StudioView, open the Scenario editor by navigating to Tools > Scenario editor,
or by clicking .
2.
Open the scenario or trajectory of your choice, or start a new one. For more inform-
ation, see
"Configuring a Scenario" on page 148 .
3. To add a jamming source to your scenario, go to Signals tab, and under Inter-
ference Signals add a new signal by clicking , or edit an existing signal.
1
Pseudo-Random Noise
4.9 Studioview Tasks
User Manual GSG-5/6 Series Rev. 27 157