Omron NJ101-10 Series, User Manual

Page: 60 / 280

2-2-2
Setting the Node Address from the Sysmac Studio
Use the Sysmac Studio to set the node address if there are no hardware switches or the node address
is beyond the range that can be set with the hardware switches.

Setting Procedure
1
Start the Sysmac Studio and go online with the Controller.
2
Double-click EtherCAT under Configurations and Setup on the Multiview Explorer. Or, right-
click EtherCAT under Configurations and Setup and select Edit .
3
Right-click the EtherCAT master that is displayed in the EtherCAT Tab Page and select Write
Slave Node Address .
The Slave Node Address Writing Dialog Box is displayed.
Refer to
When the Slave Node Address Writing Dialog Box Is Not Displayed on page 2-11 if
the dialog box is not displayed.
2 Part Names and Slave Settings
2-10
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)