Omron NJ101-10 Series, User Manual

Page: 268 / 280

The transmission delay time is calculated based on the measured value in the actual network
configuration. After the actual measurement is completed, the calculated transmission delay
time will be displayed on
Calculation result from the measured value in the actual network
configuration .
3
Select Calculation result from the measured value in the actual network configuration
and click the OK Button.
The calculated transmission delay time is set to the transmission delay time in the network con-
figuration information for the project.
Additional Information
The set transmission delay time is displayed on Calculation result from the measured value
in the actual network configuration in the Transmission Delay Time Setting Dialog Box,
even offline.
The following dialog box is displayed.
4
Click the OK Button and then perform synchronous transfer to send the project to the CPU
Unit.
Precautions for Correct Use
If you changed the actual network configuration after the transmission delay time that was cal-
culated by actual measurement was set to the project, perform the actual measurement again.
When you transfer a project without actual measurement, the transmission delay time that was
calculated by the previous actual measurement is set to the CPU Unit.
Appendices
A-32
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)