Oce VarioPrint 2105, Manual For Use

Page: 41 / 266

Introduction 41
station or the print station is not in the sleep mode, the screen of the operator
panel is on.
Low power mode
When the print station is in low power mode, this indicates that the power
consumption is decreased to lower level. It will take up to 4 minutes to turn the
print station into stand-by mode.
The print station turns into the low power mode when the station is not used
for some time. The low power mode timer settings indicate this time. If the Océ
VarioPrint 2105 must be active to print a document, the print station
automatically returns to the stand-by mode.
Note:
Only the print station can turn into the low power mode. You can not put
the print station into low power mode manually (only by timer).
Process or stand-by mode
Both stations can be in process mode or stand-by mode separately.
The print station is in process mode when it prints a job. The scan station is in
process mode when it scans a job.
The scan station and the print station are in stand-by mode when they are not
processing a job. When a job needs to start, the stations are active immediately.
There is no extra warm-up time.
Warm-up time
You can adjust the warm-up time of the Océ VarioPrint 2105 to take into
account special climate conditions. The warm-up time is the time the system
needs to become operational when you start the system. You can increase the
standard warm-up time with 5 minutes to decrease the effect of moisture on the
print quality caused by condensation. Configure the warm-up time