Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 152 / 368

Replacing a hard drive, tape drive, CD-ROM drive, or floppy drive Standard 1.0
152 CallPilot
Replacing a hard drive
Introduction
The hard drives are hot-swappable. This means that you can replace a hard
drive without powering down the server.
When to hot-swap hard drives
With a RAID controller, hot-swap device drivers, and operating system
support, SCA SCSI hard drives can be hot-swapped on the 1001rp server.
Without the RAID controller, hot-swap device drivers, and operating system
support, replacing a drive during server operation can cause a fatal error and
force a system restart. If a RAID controller is not installed, shut down the
system first and then replace the drives.
Note: Identify which hard drive to remove using the Windows NT Event
Viewer (see “Viewing event logs” on page 42).
RAID SCSI hard drive configuration
The table below indicates proper SCSI drive bay, channel, and ID
configurations in the hot-swappable drive bay. The SCSI backplane assigns
the SCSI IDs as shown in the table below:
Hard drive bay
SCSI
channel
SCSI ID Logical drive
a
1 (far left) 1 0 0 (primary hard drive)
2 1 1 1 (primary hard drive)
3 1 2 2 (primary hard drive)
4 1 3 0 (secondary hard drive)