Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 252 / 368

Performing RAID maintenance Standard 1.0
252 CallPilot
8 Click OK in the Rebuild Drive dialog box, and then click OK in the Rebuild
Progress dialog box to return to the Device Selection dialog box.
Result: The rebuilt drive is shown as being online (ONL).
9 Repeat steps 7 and 8 for the remaining two dead drives.
10 Once all hard drives have been rebuilt, click OK in the Device Selection
dialog box to return to the DAC Administration Utility window. Then exit
the DAC Administration Utility.
Result: You have completed the upgrade procedure.
Reverting to the pre-upgrade system (if the upgrade fails)
This section describes how to restore the CallPilot server to the state it was
in before you began the upgrade. This procedure includes the following
steps:
1. Mark the failed upgrade hard drives dead.
2. Reconnect the pre-upgrade hard drives.
3. Enable the pre-upgrade hard drives and restore the pre-upgrade software.
To mark the failed upgrade hard drives dead
1 Insert the CallPilot 2.0 OS Recovery or OS Upgrade CD into the CD-
ROM drive and then power up the computer.
Note: In order for this procedure to work the computer BIOS must have
booting from CD-ROM enabled. You may need to enter the BIOS setup
to enable booting from CD-ROM.
Result: The system boots and the "MS-DOS 6.2 Start Menu" is
displayed.
2 Use the up and down arrow keys to select "8. Other Utilities (BIOS,
firmware, Etc.)..." and press Enter.
Result: The "*** Other Utilities ***" menu is displayed.
3 Press 3 to select "3. Mylex DAC960 RAID Card Configuration Utility".
Result: The DAC960 Configuration Utility main menu appears.