Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 271 / 368

October 2002 Replacing or adding voice processing boards
Part 5: 1001rp Server Maintenance and Diagnostics 271
4 Remove the faulty MPB16-4 board from its slot, and save the retaining
screw.
5 Remove any optional MPC-8 cards from the faulty MPB16-4 board, and
install the cards in the new MPB16-4 board.
Note: If some MPC-8 cards were identified as faulty, ensure that these
are replaced with new MPC-8 cards in this step.
6 Press the new MPB16-4 board firmly into its slot.
Note: Ensure that you carefully slide the MPB16-4 board past the
protective foil strips, as they are easily damaged.
7 Secure the board using the retaining screw that you removed earlier.
8 Reconnect the SCbus cable to the new MPB16-4 board.
Note: If there is only one MPB16-4, the SCbus cable is not used.
9 Reconnect the DS30X cable to the faceplate of the new MPB16-4 board.
10 Replace the server cover.
Note: Be careful not to pinch any cabling when replacing the server
cover.
11 Replace the front bezel and lock it.
12 Reconnect the power cables to the server and to the peripheral devices.
13 Restart the server, and then log on to Windows NT.
14 Run the Configuration Wizard to detect the new hardware.
Result: The MPB16-4 board replacement procedure is completed.
15 Test the multimedia channels to ensure the new MPB16-4 board is
functioning properly.
Refer to “Testing the CallPilot installation” in Part 3 of the CallPilot
Installation and Configuration binder.