Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 318 / 368

Maintaining the Pentium II SBC card Standard 1.0
318 CallPilot
The system may work with a simple swap of boards. However, the stability
of the system may be affected and unexpected behavior can occur.
Therefore, a full reinstall is always necessary.
Materials you need
Before replacing the SBC card, gather the following items:
one Phillips-head screwdriver
one antistatic wrist strap
the replacement SBC card
SDRAM P100 DIMMs with gold-plated edge connectors (these are the
memory module(s) for the Pentium III card)
cable labels
Procedure overview
1 Gather the required materials.
2 Back up the system.
This is applicable only if an upgrade is being performed. If the original
server has had a recent backup, then go to the next step. If the SBC has
crashed, then you must use a previous backup. Refer to chapter 6,
“Performing system backups,” in the
Monitoring and Security Guide for
details.
3 Install DIMM(s) on the new Pentium III SBC.
Note: You must place the Pentium III card on a flat surface, and then
perform the procedure.
4 Remove the Pentium II SBC.
.
CAUTION
Risk of system corruption
A full reinstall of the system as detailed below must be
performed. Failure to do so can result in system corruption.