Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 288 / 368

Replacing the network cards Standard 1.0
288 CallPilot
Replacing Ethernet CLAN cards
To replace the 3Com PCI Ethernet card
1 See “Slot assignments” on page 354 to determine proper slot
assignment for the CLAN card.
2 Check that the BIOS is configured to assign the correct IRQ to the
correct slots.
3 Power down the server.
4 Unplug the AC power cord.
5 Remove the chassis cover.
6 Locate the CLAN Ethernet card to be removed, and unplug its network
cabling.
7 Set aside any cables covering the card.
8 Remove the screw that fastens the card in the chassis.
9 Gently pull the card out (use a slight rocking motion).
10 Remove the new Ethernet card from its protective packaging.
Note: Place the old Ethernet card into the protective packaging.
11 Line up the new Ethernet card with the slot (PCI or ISA, as appropriate).
Note: Make sure the end-plate tab is lined up with the opening in the
chassis.
12 Press the card into the slot.
13 Secure the card to the server chassis with the fastening screw.
.
CAUTION
Risk of equipment damage
Ensure that the card is completely seated or the card will short-
circuit.