Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 290 / 368

Replacing the network cards Standard 1.0
290 CallPilot
7 Set aside any cables covering the card.
8 Remove the screw that fastens the card in the chassis.
9 Gently pull the card out (use a slight rocking motion).
10 Remove the new Ethernet card from its protective packaging.
Note: Place the old Ethernet card into the protective packaging.
11 Line up the new Ethernet card with the slot (PCI or ISA, as appropriate).
Note: Make sure the end-plate tab is lined up with the opening in the
chassis.
12 Press the card into the slot.
13 Secure the card to the server chassis with the fastening screw.
14 Replace the chassis covers.
15 Plug in the AC power cord.
16 Power up the server.
To install an Intel PCI Ethernet network card driver
1 Start with Windows NT and log on to the server as Administrator .
2 Open the Network Control panel, select the Adapters tab, and click Add...
to add the adapter.
3 Click Have Disk... to load the device driver.
4 Insert the Intel device driver disk for the CLAN card, and then press
Enter.
5 Select Intel EtherExpress PRO/100B PCI Ethernet Adapter, and then
click OK.
.
CAUTION
Risk of equipment damage
Ensure that the card is completely seated or the card will short-
circuit.