Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 324 / 368

Maintaining the Pentium II SBC card Standard 1.0
324 CallPilot
16 Slide the media drive chassis gently into the media bay.
Leave enough space to reconnect the power and I/O cables for the IDE
floppy disk drive, CD-ROM drive, and tape drive.
17 Reconnect the power and I/O cables for the IDE floppy disk drive, CD-
ROM drive, and tape drive.
18 Slide the media drive chassis completely in, and screw it into place.
19 Ensure that DIMM(s) have been installed on the SBC.
20 Identify the Switch Block (SW1) location on the SBC with the help of the
picture that follows on page 325. The Switch Block contains four DIP
switches (1-4) that you configure affecting on-board ROM access, CMOS
RAM, and configuration ports.
a. Ensure DIP switch number 1 is set to the closed/on position.
ATTENTION
Ensure that PIN 1 on the I/O cable is in the correct
position. PIN 1 on the cable is marked with a colored
stripe. PIN 1 on the drive connector is marked with a
small square or triangle. The cable is generally keyed.
.
DANGER
Risk of explosion
The SBC has a lithium battery installed. If you are discarding
the SBC, dispose of used batteries according to the
manufacturer’s instructions.
.
CAUTION
Risk of equipment damage
Do not install memory modules (DIMMs) from a Pentium II SBC
on a Pentium III SBC.