Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 256 / 368

Performing RAID maintenance Standard 1.0
256 CallPilot
To enable the pre-upgrade hard drives and restore the pre-
upgrade software
Note: Because all the hard drives are marked DED, there is a five minute
timeout of the system while the drives are scanned.
1 Insert the CallPilot 2.0 OS Recovery or OS Upgrade CD into the CD-
ROM drive and then power up the computer.
Note: In order for this procedure to work the computer BIOS must have
booting from CD-ROM enabled. You may need to enter the BIOS setup
to enable booting from CD-ROM.
Result: The system boots and the "MS-DOS 6.2 Start Menu" is
displayed.
2 Use the up and down arrow keys to select "8. Other Utilities (BIOS,
firmware, Etc.)..." and press Enter.
Result: The "*** Other Utilities ***" menu is displayed.
3 Press 3 to select "3. Mylex DAC960 RAID Card Configuration Utility".
Result: The DAC960 Configuration Utility main menu appears.
4 From the DAC960 Configuration Utility main menu, select Tools and then
press Enter.
Result: The Tools menu appears.
5 From the Tools menu, select 4. Make Online, and then press Enter.
Result: The cursor is active on the left side of the screen so that you can
select which drive to make online.
.
CAUTION
Risk of lost or corrupted data
All hard drives must be dead (DED) before you begin this
procedure. If you are not sure if all the hard drives are dead, see
“To mark the failed upgrade hard drives dead” on page 252.