Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 322 / 368

Maintaining the Pentium II SBC card Standard 1.0
322 CallPilot
3 Insert the bottom edge of the DIMM into the slot and press down firmly
on the DIMM until it seats correctly.
When the DIMM seats correctly, the release tabs lock back to an upright
position. If the DIMM does not seat correctly, remove it and reinstall. Do
not force the locking tabs to close.
4 Repeat the above two steps to install an additional DIMM.
To replace the SBC card
1 Power down the server.
2 Disconnect the power cord.
3 Remove the top cover.
4 Disconnect and label all connectors from the SBC card.
5 Remove the screw located at the top of the I/O bracket.
Note: This step is optional. The I/O bracket is the same for the Pentium II
and the Pentium III SBC; therefore, it is not necessary to replace it.
However, you are provided with a new I/O bracket with the Pentium III
SBC.
.
CAUTION
Risk of equipment damage
When installing a DIMM in slot 1, the IDE locking latch may get
in the way and cause a memory chip to snap out of the board.
.
CAUTION
Risk of damage to FDD and IDE cables
When removing or plugging the FDD and IDE cables, ensure
that you unlock them first by pressing on the latches holding
them in place. If you pull these cables without unlocking them,
you can damage them.