Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 56 / 368

Using Windows NT online diagnostic tools Standard 1.0
56 CallPilot
To run the arp command from Windows NT 4.0
1 Click Start
➝
Programs
➝
Command Prompt to display the MS-DOS
command prompt window.
Result: The MS-DOS Command Prompt window appears.
2 At the MS-DOS prompt, type arp with the required parameters (for
example, arp -g 200.286.0.32).
3 Press Enter.
Result: The system runs the arp command.
4 Type Exit to exit MS-DOS and return to Windows NT 4.0.
The nbtstat command
The nbtstat command displays protocol statistics and current TCP/IP
connections using NBT.
Nbtstat command syntax
The nbtstat command uses the following syntax:
nbtstat [-a remotename] [-A IP address] [-c] [-n]
[-R] [-r] [-S] [-s] [interval]
-s Adds the host and associates the Internet address inet_addr
with the Physical address eth_addr. The physical address is
given as six hexadecimal bytes separated by hyphens. The
entry is permanent.
Parameter Description
-a remotename Lists the remote computer’s name table using its name.
-A IP address Lists the remote computer’s name table using its IP
address.
Parameter Description