Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 229 / 368

October 2002 Performing RAID maintenance
Part 5: 1001rp Server Maintenance and Diagnostics 229
2 Use the up and down arrow keys to select "8. Other Utilities (BIOS,
firmware, Etc.)..." and press Enter.
Result: The "*** Other Utilities ***" menu is displayed.
3 Press 3 to select "3. Mylex DAC960 RAID Card Configuration Utility".
Result: The DAC960 Configuration Utility main menu appears.
4 Select New Configuration, and then press Enter.
Result: The New Configuration menu appears.
5 Select Define Pack, and then press Enter.
Result: The Pack Definition menu appears.
6 Select Create Pack, and then press Enter.
Result: The cursor control moves to the disk configuration layout so you
can select which drives constitute the first system pack.
7 Use the tables in “RAID system pack locations and identifications” on
page 226 to identify the SCSI ID and Channel Number for hard drive A-0.
Use this information to select the drive that will be A-0, and then press
Enter.
Result: The device is labeled A-0 and is the first drive for System Pack
A. The drive’s state is changed from RDY to ONL.
8 Use the tables in “RAID system pack locations and identifications” on
page 226 to identify the SCSI ID and Channel Number for hard drive A-1.
Use this information to select the drive that will be A-1, and then press
Enter.
Note: You may be warned that you are combining two drives of different
sizes. If this happens, you must ensure that you are using CallPilot
qualified hard drives, as well as the approved version of the DAC960
Configuration & Utilities disk (see “Requirements” on page 225).
Result: The device is labeled A-1 and is the second drive for System
Pack A. The drive’s state is changed from RDY to ONL.
9 Press Esc to close this pack.
Result: The cursor control moves to the Pack Definition menu.