Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 295 / 368

October 2002 Maintaining the Pentium II SBC card
Part 5: 1001rp Server Maintenance and Diagnostics 295
2 Push the DIMM release tab outwards at both sides of the DIMM to be
removed.
3 Hold the DIMM by its edges, being careful not to touch its components.
Remove the DIMM by lifting it away from its slot. Store it in an antistatic
package.
4 Remove other DIMMs as necessary.
5 Orient the DIMM so that the two notches in the bottom edge of the DIMM
align with the keyed slot.
6 Insert the bottom edge of the DIMM into the slot, and press down firmly
on the DIMM until it seats correctly.
Note: When the DIMM seats correctly, release tabs lock back to an
upright position. If the DIMM does not seat correctly, remove it and
reinstall. Do not force the locking tabs to close.
7 Repeat the above two steps to install each additional DIMM.
8 Replace the SBC card in the server.