Nortel CallPilot 1001rp, Installation And Configuration Manual

Page: 303 / 368

October 2002 Maintaining the Pentium II SBC card
Part 5: 1001rp Server Maintenance and Diagnostics 303
7 Power off the server after seeing the above message.
8 Return DIP switch 3 to the OFF position.
9 Replace the top cover.
10 Restart the system.
11 Configure the BIOS as described in the following procedure.
To configure the Pentium II SBC BIOS
1 Power on the system, and then press F2 to enter the CMOS Setup.
Note: For the following steps, use the arrow keys to navigate menus, and
press Enter to make a selection.
Result: The Setup Utility starts. The screen has two areas:
Options: The Options menu is on the left side of the screen, and is
composed of Basic options, Advanced options, and PCI options.
Summary Information: The current settings appear on the right side of
the screen.
2 Press F9 to accept the default values.
3 Press Enter when prompted to confirm this change.
4 Change values as required for CallPilot. Refer to the BIOS tables,
starting with “Pentium II BIOS basic options” on page 305.
5 Save and exit the CMOS Setup.
Crisis recovery
There are special cases when the BIOS data is corrupted or an invalid user
configuration has been entered because an incorrect BIOS file has been
flashed. In some cases, the SBC does not start at all or it displays nothing on
the screen.