NorAM 65E Turbo Motor Grader, Service Manual

Page: 257 / 830

R e p a i r M a n u a l
Corporate Division
Off-Road Driveline Technology
and Axle Systems
5871 146 002 7/3
Remove bearing outer rings (arrows) from the housing front part.
If, contrary to the ZF recommendation, the tapered roller
bearings of clutches, input and output are not replaced, it is
imperative to ensure the previous pairing (bearing outer
ring/ bearing inner ring).
Bearing outer ring and bearing inner ring must be marked!
Figure 9
Lift the clutches out of the housing in numerical order as
described in the legend.
1 = K1 clutch
2 = K2 clutch
3 = K3 clutch
4 = K4 clutch
5 = KR clutch
6 = KV clutch
7 = input shaft
Figure 10
Remove bearing outer rings (arrows) from the housing rear part.
If, contrary to the ZF recommendation, the tapered roller
bearings of clutches, input and output are not replaced, it is
imperative to ensure the previous pairing (bearing outer
ring/ bearing inner ring).
Bearing outer ring and bearing inner ring must be marked!
Figure 11
The lubrication lines are rolled in (1 and 2) and are highly
difficult to remove.
In case of damage, use of the appropriate ZF special tool is
imperative for fitting or replacing these components.
Figure 12
2
1
3
6
4
5
7
2
1