NorAM 65E Turbo Motor Grader, Service Manual

Page: 124 / 830

65E Turbo Motor Grader
Service Manual
Service 2.00_2013.03 4 - iv
Section 4
Transmission
15. Install all shields before starting or operating machine.
16. Do not operate an unsafe machine. If items are found during inspection that render a
machine unsafe, be sure any malfunctions are remedied before accepting
responsibility for operation.
17. Always properly tie down the machine to a truck or trailer before transport.
18. Do not start engine or operate controls while standing beside the vehicle. Always sit in
the seat when starting engine or operating controls.
19. Do not operate an unsafe machine. Be sure that any reported problems have been
repaired and all shielding is in place before accepting responsibility for machine
operation.
20. Do not bypass transmission neutral start switch. Consult an authorized dealer if the
neutral start controls malfunction. Use jumper cables only in the recommended
manner. Improper use can result in a runaway vehicle.
21. Check brakes, steering and implement controls before moving. Advise maintenance
personnel of malfunctions before operating. Be sure malfunctions are remedied before
accepting responsibility for operation.
22. Avoid accidental contact with the transmission control lever while the engine is
running. Unexpected movement may result from such contact.
23. Do not get off or on the vehicle while it is moving.
24. Lower unlocked implements to the ground, apply parking brake and shut off the engine
before getting off the machine.
25. Do not use machine to carry loose objects or attach implements in ways other than
intended.
26. Before starting the engine, be sure that all operating controls are in neutral and the
parking brake is engaged.
27. Install lock pins in front and rear mounted implements before transporting machine
between job sites.
28. Do not park on a steep incline.
29. Do not operate the vehicle in an enclosed building without adequate ventilation.
Exhaust fumes can cause death.
30. If the power steering or engine ceases to operate, stop the vehicle immediately.
31. Stop the engine and relieve pressure before connecting or disconnecting hydraulic,
steering or fuel lines.
32. Tighten all connections before starting engine or pressurizing lines.