NorAM 65E Turbo Motor Grader, Service Manual

Page: 182 / 830

ERGOPOWER
Geschäftsbereich
Arbeitsmaschinen-Antriebe
und Achssysteme
39
V. ZF-DIAGNOSTIC SYSTEMS
5.1 General:
The Control electronics EST-37 for the Transmission Series Ergopower is equipped with a
diagnostic package, which makes the Trouble shouting and the elimination of Repairs easier
for the Service.
The Electronics is able to monitor the states of certain inputs and outputs.
If the Electronics recognizes during it an error, it stores an error code in the fault storage
(EEPROM) and is transmitting the error code also to the vehicle controller of the Vehicle Ma-
nufacturer.
The ZF-Diagnosis and the Programming systems MOBIDIG-2001 (see 5.2) and LAPTOP-
Version (see 5.3) are needed for the following applications:
Diagnosis - Actual errors
- Read fault storage
- Cancel fault storage
AEB - Automatic calibration of the shifting elements
Testing Inputs and Outputs - Outputs
- Check inputs
- Check systems downtime
- System test drive
Additionally for the Diagnosis can be used the Multi-System 5000 (see 5.4) with correspon-
ding sensor system for pressure, temperature, speed, through-flow, current transformer etc.
5.2 ZF - MOBIDIG 2001
The ZF-Diagnostic system MOBIDIG 2001 is only reserved to ZF-Service Stations.
All necessary, transmission-specific Data for a quick and comprehensive Diagnosis
can be retrieved with this Diagnostic system.
The Data are stored on CD-Rom and will be updated 2 – 3 times a year.
It can be universally utilized for all diagnosis-capable ZF-Vehicle systems.
MOBIDIG 2001 with
ZF-Diagnostic Software
Diagnostic Software with Operator
guidance
6008 307 001
Terminal tester 68-pin
For the test of single control signals, line
connections etc.
6008 304 038
Figure-No.: 5.2