Nokia Network Voyager, Reference Manual

Page: 370 / 700

7
Configuring Traffic Management
372 Voyager Reference Guide
Note
This is the most efficient approach to building a cluster and will configure
all the cluster nodes consistently.
Joining a System to a Cluster
To join a system to a cluster, perform this simple procedure:
1.
On the main configuration page, click Interfaces to display the Interface
Configuration page.
2.
Configure interfaces with IP addresses in each of the networks used by
the cluster and activate the interfaces.
3.
Click T
OP
.
4.
Under Traffic Management Configuration, click Clustering Setup to
display the Clustering Setup Configuration page.
5.
Enter the ID of the existing cluster.
6.
Enter the password for the user cadmin in both password fields.
Note
This must be the same password that you entered for cadmin when
you created the cluster on the first node.
7. Click A
PPLY
8.
In the
C
LUSTER NODE ADDRESS
field, enter an IP address that meets the
following criteria:
!
You should use an address of an interface on the cluster node that you
configured first .