NF ZM2371, Instruction Manual

Page: 54 / 255

3.5 Basic Operations
3-24 ZM2371/ZM2372

Trigger source
Press the
_ SHIFT _ + [TRIG MODE]
keys to display the trigger setting menu (see below),
and set the trigger source with a numeric key.
TRIG SRC:Ext Delay=100.000s SRC Sync=ON
Current setting
0)Int 1)Man 2)Ext 3)Bus 4)Delay 5)S.Sync
Options
Int Internal. Automatic repetitive measurement (default)
Man Manual. Press
_ TRIG _
key on the front panel to trigger the
measurement.
Ext External. The trigger signal of handler interface is used to trigger the
measurement.
Bus Remote control

Measurement range
The default setting is automatic selection.
Press the
_ AUTO/HOLD _
key, so that Automatic selection (Auto) and Manual selection
(Hold) can be switched.
Press the
_ SHIFT _ + [RANGE]
keys to display the measurement range setting menu (see
below), and press a numeric key
(
_ 0 _
key or
_ 1 _
key) to change the measurement range
manually. The range is held (manual selection).
RANGE : Manual 1k

Rd : 25

-
Current setting
0)DOWN 1)UP 100m

to 1M

2)Rd-min
Options
When a measurement range value is large, it is approximate the lower limit of
measurement range, or when a value is small, it is approximate the upper limit of
measurement range.
For details

“Table 3-2 Measurement rang list’’
_ SHIFT _ _ TRIG _ | [TRIG MODE]
_ AUTO/HOLD _ | [RANGE]

Connection of DUT and measurement

Connection of DUT
Referring to
“3.4 Connection of DUT”
, connect the LCR meter to the DUT.

Manual trigger
Set the trigger source to “Manual”, and press the
_ TRIG _
key, so that the trigger signal is
applied and the measurement is executed once.