NF ZM2371, Instruction Manual

Page: 36 / 255

3.2
Display at Power “ON” and Initial Setting
3-6 ZM2371/ZM2372
3.2.3 Initialization
ZM2371 / ZM2372
is reset to the factory default settings in the following cases:

At the time of shipment from factory
All settings and correction values including operation modes and memory contents are
set to the initial values.

When full initialization of settings is specified
Except operation modes, the memory contents, settings, and correction values are reset
to the factory default settings.

“4.10 Initialization of All Settings”

At the power ON, if backed up setting or correction value is faulty
Faulty part is initialized.

“3.2.2 Displays and Indications at Power “ON” “

When operation mode is switched
The settings and correction values except operation modes are all initialized including
memory contents.
In general, the initial values vary depending on the operation modes.
For the operation modes other than standard operation mode (MODE 0), see Chapter 6.
To start the operation from the initial setting state, perform initialization as follows:
・
After pressing
_ SHIFT _
key, press
_ 0 _ | [INIT]
key to display the initialize menu, and
press
_
1
_
key.
Initialized items, initialized contents

“Table 3-1 Setting items and initial values”