NEC Univerge SV9100, System Hardware Manual

Page: 298 / 556

Issue 2.0
4-60 Installing the SV9100 Blades
3. Connect the cable from the NT1 Network Termination cable to the
CN7 or CN8 connector on the GCD-2BRIA blade and/or GPZ-2BRIA
daughter board. (Refer to
Figure 4-21 GCD-2BRIA Blade on page
4-58 for the location of the connectors on the blade.)
5.3.3 LED Indications
LED indications for the GCD-2BRIA are listed in Table 4-24 GCD-2BRIA
LED Indications . Each LED is listed with its associated function and LED
and Operational status.
Refer to Figure 4-21 GCD-2BRIA Blade on page 4-58 for the location of the
LEDs on the blade.
Table 4-24 GCD-2BRIA LED Indications
LED Indication
Operation Status Remarks
Live LED
(Green)
Busy LED (Red)
On On System Initializing –
Flash (1s) On The assignment of the unit is refused.
When you exceed the system
capacity.
When the main software version is
not matched.
Flash (1s) Trouble found during self-diagnostics. –
Flash
(100ms)
On
Normal
Operation
A Channel is busy (use
another from CH1 ~ CHx). –
Off All channels are idle. –
Off
On
Unit Busy
A Channel is busy (use
another from CH1 ~ CHx). –
Off All channels are idle. –
Flash 80ms (On/
Off) x 3/400ms
Off
Downloading firmware. –