Preparing for a job
Operation Instructions Rockhopper Printer
Page
60
AP-75024 Rev. 1.2. – 18/08/2002
Note :
To find the optimum correction value for a certain media, you will need to
go through a series of test cycles. Preferably send to the plotter a small
test image such as a neutral grey square (between 50% and 70% Grey)
and check the micro-banding as described above. Make a note of your
correction value for a certain media type, as the required value will always
be the same for this media type.
Note :
Before using this function, always perform a nozzle-check to see if all
nozzles are firing correctly. Nozzles which are not firing or misfiring might
mislead you when entering correction values.