Installation Procedures
Operation Instructions Rockhopper Printer
Page
26
AP-75024 Rev. 1.2. – 18/08/2002
Step 4:
Caution:
•
For safety, at least four people are needed for assembling the printer.
•
When taking the main unit out of the carton, remove the vinyl first and
handle the printer directly. There is a risk of your hands slipping if the
main unit is handled with the vinyl on.
•
The main unit must be lifted by four people at the places marked (1) to
(8) below. If it is lifted at other places (left and right side covers, ink
cartridge cover, etc.) the printer may fall and cause injury or damage.
Fix the printer body onto the leg assembly using the two wing
screws. As mentioned in step 2 & 3 the end plates should be pulled
as much as possible towards the upper part of the stand. To do so,
loosen a little bit the bolts temporarily fixing the endplates with a hex
key of 3 mm and make sure that they are pulled as much as
possible towards the stand. Now you can fix both wing screws
firmly. Once the wing screws are fastened, you can secure the
bolts on the endplates (see step 2 & 3) firmly with the hex key.