Preparing for a job
Operation Instructions Rockhopper Printer
Page
48
AP-75024 Rev. 1.2. – 18/08/2002
Step 13:
During the media detection sequence, check if the media runs straight. After media
detection, check the position of the right side of the roll media. If the position is almost on
the same line as it was before closing the cover, media loading was performed
successfully. If after the media detection sequence, the roll media position is not on the
same position as it was before closing the cover, repeat the instructions from steps 8 and
9 for installing the media.
Note:
Removing roll media
Step 1:
After printing, open the cover, tilt the media hold lever UP and wind up
the roll media.
Step 2:
Stand behind the printer. Unlock the scroller
receiver by pressing the lock lever down.
You can now lift the right side of the scroller
and remove it from the printer.
Step 3:
Remove the roll media by gently pushing the roll media off the scroller via
the moveable flange side.
At no times drop the scroller end-caps on the floor as this might damage
the scroller end-caps and reduce media tracking or loading problems.
3. Loading media in combination with the Roll Take-Up System.
Step 1 :
Open the cover and put the hold lever in the UP position by tilting it up(wards).