Preparing for a job
Operation Instructions Rockhopper Printer
Page
50
AP-75024 Rev. 1.2. – 18/08/2002
1 = Fixed flange
2 = Media winding direction
Note :
•
Do not drop the media roll over the scroller as this might damage
the scroller end caps. Damaged end caps may cause media
tracking problems.
•
All Mutoh recommended roll media are rolled up with the printable
side facing the outside, so that you can load the roll media easily.
Step 7: Installing the scroller slip ring
Install the scroller slip ring onto the scroller. Slide the scroller slip ring on the left side of
the scroller (side with fixed flange).
Step 8 : Installation of the scroller.
Install the scroller as follows :
a) Stand at the back side of the printer, holding the scroller with the fixed flange side in
your left hand.
b) Slide the scroller (left side) into the scroller receiver, as shown in the illustration.
c) Push the scroller (Right side – movable flange side) down into the right scroller
receiver. You will notice it dropping nicely into place.