Installation Procedures
Operation Instructions Rockhopper Printer
Page
17
AP-75024 Rev. 1.2. – 18/08/2002
INSTALLATION PROCEDURES
Warning:
Make sure to connect the power cable only after all the steps of the
installation procedure are completed.
INSTALLATION REQUIREMENTS: SELECTING AN ADEQUATE
PLACE FOR SETTING UP YOUR EQUIPMENT
The location where you set up your equipment is very important. Please see to it that it
meets following conditions:
♦
Power supply:
- Voltage:
200 to 240 VAC or 100 to 120 VAC
- Frequency:
50/60 Hz ± 1 Hz
- Current:
< 10 A (110 V)
< 5 A (220 V)
♦
Ambient conditions:
•
Operating environment
- Temperature: 10°C to 35°C
- Humidity: 20% - 80% non-condensing
•
Storage environment
- Temperature: -10°C to 60°C
- Humidity: 20% - 90% non-condensing
•
Variation rate
- Temperature: 2°C per hour
- Humidity: 5% per hour
♦
Do not connect the printer to a power supply used by other devices that could interfere
with your printer.
♦
Do not use thinner, benzene or similar agents on the printer.
♦
Only use original Mutoh ink cassettes. Use of different ink cassettes might cause
damage to your printer. When using non Mutoh ink cassettes, the ink supply system,
the heads as well as the cleaning system will be considered out of warranty.
♦
Keep ink cassettes out of the reach of children.
♦
Store your ink cassettes in a cool place. The Rockhopper ink could get frozen,
however, if you store your ink below -18°C. In this case, leave your cassettes at room
temperature for at least three hours before using them.