Preparing for a job
Operation Instructions Rockhopper Printer
Page
47
AP-75024 Rev. 1.2. – 18/08/2002
•
Turn the scroller receiver screw clockwise to
move the roll media to the left (when standing
in front of the printer).
Important:
•
The guide line (holes) is a guide.
There is a possibility of a jam if the pressure roller is not holding the
left edge of the media and the pressure roller is near the right edge.
Either hold the left edge of the media completely with the pressure
roller or slide it so that the pressure roller is about 5 mm away from
the right edge of the media and the right edge of the media within 5
mm to the left or right of the guide line (holes).
Step 12:
•
Check if the roll media has been installed correctly.
•
Lower the media hold lever and close the cover.
•
The head moves automatically and detects the media size.
•
The display will show the following message during loading:
•
After performing its media loading sequence (± 30 seconds) the printer displays the
following message:
Important:
•
If the roll media has not been fed straight or incorrectly,
messages such as, “media error” or “media jam error” are
shown on the display. If this is the case, reload the media
following the instructions above.
ConfirmPaperKind
Plot OK