Installation Procedures
Operation Instructions Rockhopper Printer
Page
28
AP-75024 Rev. 1.2. – 18/08/2002
Step 6:
Loosen the wing screw which is fixed to the printing table (4) and remove the metal fixing
plate (5), which blocks the printer head during transportation. (See
4
&
5
on figure below).
Keep the metal fixing plate and wing screw, since the printing head needs to be
blocked during any transportation of your printer.
Caution:
•
Take care not to drop the wing screw inside the printer body. Should
it fall in, do not boot up your printer until the wing screw has been
safely removed.
Remove the tape that locks the sheet-off mechanism during transportation
(See
6
on figure below).
Step 7:
Remove the cable block(s) between rail and cover (
7
).
Remove the lever block (
8
).
Step 8 :
Install the Waste Bottle (2 screws). Do not forget to connect the connector and the waste
tubes.
Step 9:
After setting up the printer, wheel it to the
desired location and lock the caster wheels.