Motion Control Engineering Nidec iControl, User Manual, Page: 209 / 453

6-24 Manual # 42-02-2223
Troubleshooting
Construction Cartop Inspection Operation, Cnstr Cartop Insp, Cnstr CT Insp
Description: Car on Construction mode/Cartop Inspection. When iBox in construction mode, it is always “on
inspection.” It will only operate in Cartop or Machine Room inspection. Cartop has precedence. If neither
modes is selected, controller enters non-specific inspection mode, will not run for any inspection input.
Car Reaction: The car can be moved using the cartop inspection key switches.
Troubleshooting:
1. If it appears that the car is on Cartop Inspection operation in error, verify wiring to the iBox INCT input.
If no voltage exists on this input, the car will operate under Cartop Inspection operation.
Construction Hoistway Access Inspection Operation, Cnstr HA Inspection, Cnstr HA Insp
Description: Car is on construction mode and hoistway access.
Car Reaction: Car is out of service and cannot be moved using the hoistway access Up or Down switches.
Troubleshooting: When on Construction mode, hoistway access switches ignored. Car can only move on
Machine Room, Cartop Inspection. Place car on inspection and use switches to move.
Construction Inspection Operation, Cnstr Inspection
Description: Car in Inspection mode and Construction setting selected on Safety Configuration screen.
Car Reaction: Car will operate using Inspection pattern on Cartop or machine room inspection only.
Construction Machine Room Inspection Operation, Cnstr Mach Room Insp, Cnstr MR Insp
Description: Car is on inspection mode using the iBox inspection switch while on construction mode.
Car Reaction: Car begins operating in Inspection mode. If running, car will make an emergency stop and is
taken out of normal service. In this mode, car can be moved using iBox Inspection Up and Down switches.
Troubleshooting:
1. Related inputs: MachineRoomInspection: Normally high
Controller Main Computer Startup
Description: iBox main processor booting up.
DBD Mode Activated
Description: Destination Based Dispatching active.
DBD PHE Antinuisance
Description: DBD Photo Eye Antinuisance option set and although a call had been assigned to car per source
floor entry, photo eye has registered no passenger entry and calls assigned to the car have been cancelled.
Car Reaction: Car is available for new assignment.
Troubleshooting: If in error, check photo eye. If functionality not desired, turn OFF DBD Antinuisance.
Demand Down Peak Mode, DEMAND DOWN PEAK MODE
Description: Car is running in Demand Down Peak mode, favoring traffic in down direction as configured on
group control screens.
Demand Up Peak Mode, DEMAND UP PEAK MODE
Description: Car is running in Demand Up Peak mode, favoring traffic in up direction as configured on group
control screens.
Developer Data Trap Triggered
Description: Custom data trap has detected event to save relevant fault information to BBRAM. The informa-
tion for ten events is stored. Additional events overwrite the information for the oldest event.
Car Reaction: None
Troubleshooting: None
Dispatcher = Car ‘n’, DISPATCHER = CAR’n’ (n = 1 to 15)
Description: Communication with main iCue dispatcher lost or not established. Car is communicating with
Car 'n' (n = 1 to 15) which is acting as backup dispatcher.
Troubleshooting: Check the group to car communication related connections and parameters.
Table 6.3 iControl Messages
iControl Messages