3 - 2
3 DESIGN
CAUTION
Provide appropriate circuits external to the Motion controller to prevent cases where danger
may result from abnormal operation of the overall system in the event of an external power
supply fault or the Motion controller failure.
Mount the Motion controller, servo amplifier, servomotor and regenerative resistor on
incombustible material. Mounting them directly or close to combustibles will lead to fire.
If a fault occurs in the Motion controller or servo amplifier, shut the power OFF at the servo
amplifier’s power source. If a large current continues to flow, fire may occur.
When using a regenerative resistor, shut the power OFF with an error signal. The regenerative
resistor may abnormally overheat due to a fault in the regenerative transistor, etc., and may
lead to fire.
Always take heat measures such as flame proofing for the inside of the control panel where the
servo amplifier or regenerative resistor is mounted and for the wires used. Failing to do so may
lead to fire.
Do not apply a voltage other than that specified in the instruction manual on any terminal.
Doing so may lead to destruction or damage.
Do not mistake the polarity ( + / - ), as this may lead to destruction or damage.
Summary of Contents for MR-MQ100
