Mitsubishi Electric MR-MQ100, User Manual

Page: 50 / 272

2 - 27
2 SYSTEM CONFIGURATION
POINT
(1) Be sure to connect SSCNET cable as per above. If the connection is
incorrect, communication between the Motion controller and servo amplifier is
not possible.
(2) The SSCNET connector has a cap to protect the optical device inside from
dust. For this reason, do not remove the cap until just before connecting the
SSCNET cable. Also, when removing the SSCNET cable, be sure to put
the cap back on.
(3) Be sure to keep the SSCNET fiber optic protective cap and tubing in a
sealed plastic bag to prevent them from becoming dirty.
(4) Do not remove the SSCNET cable while the power supply of the Motion
controller or servo amplifier is turned on.
Do not look directly into the light generated from SSCNET connector of the
Motion controller, servo amplifier or from the end of SSCNET cable. The light
can damage the eye. (The light source of SSCNET cable complies with
class1 defined in JISC6802 or IEC60825-1.)
(5) When replacing the servo amplifier or the Motion controller, be sure to put a
cap on the SSCNET connector. When sending a servo amplifier or Motion
controller back for repairs, also be sure to put a cap on the SSCNET
connector. Without a cap, the light device may be damaged during transit. If
this is the exchange or repair of the light device will be required.
(2) Cable specifications
(a) MR-J3BUS M
Model name
Item
MR-J3BUS015M MR-J3BUS03M MR-J3BUS05M MR-J3BUS1M MR-J3BUS3M
Cable length [m(ft.)] 0.15(0.49) 0.3(0.98) 0.5(1.64) 1(3.28) 3(9.84)
(b) MR-J3BUS M-A
Model name
Item
MR-J3BUS5M-A MR-J3BUS10M-A MR-J3BUS20M-A
Cable length [m(ft.)] 5(16.40) 10(32.81) 20(65.62)
(c) MR-J3BUS M-B
Model name
Item
MR-J3BUS30M-B MR-J3BUS40M-B MR-J3BUS50M-B
Cable length [m(ft.)] 30(98.43) 40(131.23) 50(164.04)