Mitsubishi Electric MELSERVO MR-J3 A Series, Instruction Manual

Page: 34 / 460

1 - 13
1. FUNCTIONS AND CONFIGURATION
(3) MR-J3-200A MR-J3-350A
Rating plate
Section 1.5
Operation section
Used to perform status display, diagnostic, alarm and
parameter setting operations.
MO UP DO SET
Cooling fan
Display
The 5-digit, seven-segment LED shows the servo
status and alarm number.
Name/Application
Detailed
Explanation
Used to change the
display or data in each
mode.
Used to set data.
Used to change the
mode.
MODE UP DOWN SET
Main circuit power supply connector (CNP1)
Connect the input power supply.
RS-422 communication connector (CN3)
Connect with the personal computer.
USB communication connector (CN5)
Connect with the personal computer.
Analog monitor connector (CN6)
Outputs the analog monitor.
I/O signal connector (CN1)
Used to connect digital I/O signals.
Servo motor power connector (CNP3)
Connect the servo motor.
Control circuit connector (CNP2)
Connect the control circuit power supply/regenerative
option.
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Encoder connector (CN2)
Used to connect the servo motor encoder.
Battery connector (CN4)
Used to connect the battery for absolute position data
backup.
Battery holder
Contains the battery for absolute position data backup.
Chapter 6
Chapter 6
Section 3.1
Section 3.3
Section 12.8
Chapter 13
Section 12.8
Section 3.2
Section 3.4
Section 3.2
Section 3.4
Section 3.4
Section 12.1
Section 12.9
Chapter 14
Section 14.3
Protective earth (PE) terminal ( )
Ground terminal.
Fixed part
(3 places)
Section 3.1
Section 3.3
Section 3.1
Section 3.3
Section 3.1
Section 3.3