Mitsubishi Electric MELSERVO MR-J3 A Series, Instruction Manual

Page: 211 / 460

6 - 18
6. DISPLAY AND OPERATION SECTIONS
6.9.2 Jog operation
POINT
When performing jog operation, turn ON EMG, LSP and LSN. LSP and LSN can
be set to automatic ON by setting parameter No. PD01 to " C ".
Jog operation can be performed when there is no command from the external command device.
(1) Operation
Hold down the "UP" or "DOWN" button to run the servo motor. Release it to stop. When using the servo
configuration software, you can change the operation conditions. The initial conditions and setting ranges
for operation are listed below:
Item Initial setting Setting range
Speed [r/min] 200 0 to instantaneous permissible speed
Acceleration/deceleration time constant [ms] 1000 0 to 50000
How to use the buttons is explained below:
Button Description
"UP"
Press to start CCW rotation.
Release to stop.
"DOWN"
Press to start CW rotation.
Release to stop.
If the communication cable is disconnected during jog operation performed by using the servo configuration
software, the servo motor will be decelerated to a stop.
(2) Status display
You can confirm the servo status during jog operation.
Pressing the "MODE" button in the jog operation-ready status calls the status display screen. With this
screen being shown, perform jog operation with the "UP" or "DOWN" button. Every time you press the
"MODE" button, the next status display screen appears, and on completion of a screen cycle, pressing that
button returns to the jog operation-ready status screen. For full information of the status display, refer to
section 6.3. In the test operation mode, you cannot use the "UP" and "DOWN" buttons to change the status
display screen from one to another.
(3) Termination of jog operation
To end the jog operation, switch power off once or press the "MODE" button to switch to the next screen
and then hold down the "SET" button for 2 or more seconds.