X-Cell Furion 450 Assembly Manual
Created: 8/27/2008
Copyright Miniature Aircraft USA
Page 19 of 89
This document may not be distributed without permission of Miniature Aircraft USA
1B.1.a 1B.1.b 1B.1.c 1B.1.d
Building Notes:
Note that the bottom plate
contains 4 PEM nuts. One side of
each PEM nut is wider than the
other side. The side of the lower
plate which shows the wide PEM
is the TOP of the plate. Install
the frame spacers on the
BOTTOM of the plate as shown.
The flat side of the spacer is
against the carbon plate.
1B.1.e 1B.1.f 1B.1.g 1B.1.h
1B.1.i
1B.1.j
1B.1.k
1B.1.l
Building Notes:
The tail boom block plate installs
into the left frame from the
inside. The tab on the lower
pulley plate slides into the left
frame tab as shown
1B.1.m
1B.1.n
1B.1.o 1B.1.p
Building Notes:
Install frame blocks on inside of
frame using bolts seen on bolt
map which follows while
applying thread lock (except on
the lower servo mount bolts)
Note that the protrusions on the
bearing blocks faces downwards
and the upper and lower bearing
flanges face each other.
#130-230
#130-225
#130-035
#130-236
#130-220
Insert tab into
frame slot
#130-035
#130-242
#130-016
#130-239
#130-238
#130-016(2)
#130-230
#130-035
#130-016
#130-243
Wide side of PEM nuts on
opposite side
#130-035
Slot/Tab
#130-241
#130-238
#130-035
#130-002
