X-Cell Furion 450 Assembly Manual
Created: 8/27/2008
Copyright Miniature Aircraft USA
Page 53 of 89
This document may not be distributed without permission of Miniature Aircraft USA
4A.5.e 4A.5.f 4A.5.g 4A.5.h
Building Notes:
Install the two short balls on the
inside swashplate ring. Make
sure you use the right length
bolts.
Building Notes:
Install the balls on the outside
swashplate ring. Note the
positions on the ring.
4A.6 Install Swashplate/Control Rods
4A.6.a 4A.6.b 4A.6.c 4A.6.d
Building Notes:
Slip the swashplate over the
main shaft as shown.
Install the anti-rotation pin and
bolt through the anti-rotation
guide and into the remaining
threaded hole on the outer
swashplate ring
Building Notes:
Install the three equal length
cyclic control rods between the
elevator, aileron, and pitch
servo arms and the control balls
on the swashplate
4A.6.e 4A.6.f 4A.6.g 4A.6.h
Building Notes:
With the servo arms centered, if
the rods are the correct lengths
the distance between the
bottom of the swashplate plate
and the top of the upper bearing
block will be as shown.
If it is not, adjust the lengths of
all three rods accordingly.
4A.6.i
Building Notes:
If the servo arms are the correct
length, the rods will be parallel
with the main shaft when the
arms are in their centered
position.
This will ensure proper control
authority.
#130-070
#130-019
#130-019
#130-019
#130-070
#130-019
#130-019
#130-040
#130-165
Rod
Rod
Rod
13 mm
