X-Cell Furion 450 Assembly Manual
Created: 8/27/2008
Copyright Miniature Aircraft USA
Page 49 of 89
This document may not be distributed without permission of Miniature Aircraft USA
4A.2.u 4A.2.v 4A.2.w 4A.2.x
Building Notes:
Secure gyro using Velcro as
shown.
You will need to slightly trim the
Velcro width so that it fits into
the slots on each side of the
front boom support as shown.
4A.2.y 4A.2.z 4A.2.aa
4A.2.bb
Building Notes:
Refer to the Initial Setup for
Servo Centering procedure
found in the Model Setup section
of this manual
For each servo select a servo
arm and find the position that
the arms are nearly
perpendicular to the servo. Trim
and mount the arms as shown in
the following steps
Building Notes:
In the following steps you will
assemble the servo arms. Select
arms that will allow the control
balls to be placed at distance
from the servo center shown.
4A.2.cc 4A.2.dd
4A.2.ee
4A.2.ff
Building Notes:
Although the plastic links can be
installed on either side, one side
is molded differently and will
install easier with less effort.
Note the differences on the
photo.
The side of the link with the
beveled edge should be installed
first over a ball or should face
inside on a ball. The side of the
link with no bevel should face
outside on a ball.
13mm
Ball Link Orientation
No Bevel
No Ring
Beveled Edge
Mold Ring
Faces Inside
Faces Outside
Antenna Routing
