X-Cell Furion 450 Assembly Manual
Page 40 of 89
Copyright Miniature Aircraft USA
Created: 8/27/2008
This document may not be distributed without permission of Miniature Aircraft USA
3A.8 – Install T/R Pitch Change Mechanism
3A.8.a 3A.8.b 3A.8.c 3A.8.d
Building Notes:
Position the t/r bell crank as
shown and slip the assembled
pitch change mechanism over
the t/r shaft.
As you slide it in, rotate the ball
portion of the slider into the bell
crank as shown. Slide the
mechanism all the way in on the
shaft.
3A.9 – Install Tail Rotor Assembly
3A.9.a 3A.9.b 3A.9.c 3A.9.d
Building Notes:
Install the assembled t/r hub
over the t/r shaft as shown
making sure that the set screw
is aligned with the flat on the t/r
shaft. Slide the hub onto the
shaft until it is flush with the end
of the shaft. Tighten the set
screw using thread lock.
3A.9.e 3A.9.f
Building Notes:
Attach the pitch links to the t/r
blade grips as shown using
thread lock. Note that the bolts
pass through the shouldered
side of the bearing. Also note
the orientation of the t/r blades
to the grips and links.
#130-037
Install
this
way
Note flat
Rotate Slightly
#130-037
