X-Cell Furion 450 Assembly Manual
Created: 8/27/2008
Copyright Miniature Aircraft USA
Page 45 of 89
This document may not be distributed without permission of Miniature Aircraft USA
3B.3.i 3B.3.j 3B.3.k 3B.3.l
Building Notes:
Install one of the tail boom
supports as shown. They attach
to the bottom of the rear frame
and to the horizontal fin mount
Repeat for both supports
Use adhesive and thread lock as
shown
3B.3.m 3B.3.n 3B.3.o 3B.3.p
Building Notes:
When initially assembled, the
horizontal fin mount will be
spaced from the t/r transmission
as shown.
Depending on the belt tension
this may vary slightly
Install the horizontal fin in two
steps as shown
3B.3.q 3B.3.r 3B.3.s
Building Notes:
Align the horizontal fin so that it
is at a right angle to the tail fin
and main shaft.
Note that tightening the left
horizontal fin bolt tightens the
clamp and will rotate the fin
slightly counter-clockwise.
#130-038
#130-002
77mm
#130-037
(Shorter Bolt)
#130-038
(Longer Bolt)
Viewed
As 90°
Angle
#130-295
#130-002
#130-038
Dimension is approximate
