X-Cell Furion 450 Assembly Manual
Created: 8/27/2008
Copyright Miniature Aircraft USA
Page 39 of 89
This document may not be distributed without permission of Miniature Aircraft USA
3A.7.i
3A.7.j
3A.7.k
3A.7.l
Building Notes:
Install the blade grip over the
bearing stack as shown. The
mount holes on the blade grip
must align with the holes in the
bearing sleeve as shown. Use a
small allen tool to align if
necessary. Push the t/r grip
towards the center of the hub
until it bottoms out. Then install
the mount bolts.
3A.7.m
3A.7.n
3A.7.o
3A.7.p
Building Notes:
If the grips and spacer are
properly aligned, the mount
bolts will install with little effort.
If they do not thread in easily
re-check the alignment and
repeat.
3A.7.q 3A.7.r 3A.7.s 3A.7.t
Building Notes:
Install the t/r blades as shown.
The leading edge of the blades
should install as shown.
Look closely at the blade arms,
one side of the hole is threaded
and the other is not. The bolts
pass through the side that is not
threaded, through the blade and
then thread into the other side
3A.7.u 3A.7.v
Building Notes:
Partially thread the set screw
into the threaded hole on the t/r
hub. It should not protrude into
the inside of the t/r hub. Do not
use thread lock at this time.
Aligned
#130-305
Slides over bearings
Align holes
Slides over bearings
#130-032
Note relationship
of leading edge to
blade control arm
Note relationship
of leading edge to
blade control arm
Insert This way
#130-308
#130-038
Unthreaded
hole
#130-035
#130-035
