X-Cell Furion 450 Assembly Manual
Page 74 of 89
Copyright Miniature Aircraft USA
Created: 8/27/2008
This document may not be distributed without permission of Miniature Aircraft USA
For the rudder servo:
In your radio
•
Make sure the gyro is in non-heading hold mode. Refer to your gyro manufacturer as to how to enable this.
•
Rudder servo endpoints (ATV) should be at 100%
•
Make sure there is no mixing enabled for rudder channel at this point (some radios mix throttle to rudder by
default).
Gyro Setting
Rudder ATV
Rudder Mixing
On your model
•
The ball should go into a hole approx 8mm from the center of the servo wheel as shown.
•
With your rudder stick centered, rotate the servo wheel until you find a spot that it aligns properly and then
slide the servo wheel onto the servo exactly in the middle of its travel as shown. Do not use any sub-trim.
•
Now make sure that the t/r bellcrank is aligned as shown. If the servo is positioned as shown and the t/r
pushrod has been built to the recommended length, this will be very close. The 90 degree pitch slider on the
tail case should be in the center of its travel. Adjust the links as necessary to ensure this is correct.
•
Make sure you install hex nuts on the ball retainer bolts using threadlock
•
Make sure you install servo arm retainer screws
Rudder Arm Dimension
Rudder Arm Orientation
Rudder Arm Alignment
T/R Bellcrank Alignment
Use a servo wheel of the
size shown
8mm
Rudder Servo
90° Angle
90° Angle
