X-Cell Furion 450 Assembly Manual
Created: 8/27/2008
Copyright Miniature Aircraft USA
Page 33 of 89
This document may not be distributed without permission of Miniature Aircraft USA
3A.3 – Assemble/Install Tail Boom
Parts Relationship
3A.3.a
3A.3.b
3A.3.c
3A.3.d
Building Notes:
Slide the rear boom support
over the front of the boom with
the slot on the same side of the
boom as the t/r fin. Slide it to
the rear of the boom for now.
Now install the t/r servo rear
mount over the front of the
boom as shown. The slot and
servo mount are on the opposite
side of the boom from the fin.
3A.3.e
3A.3.f
3A.3.g
3A.3.h
Building Notes:
Stretch the t/r drive belt out to
make sure it is straight and not
twisted.
It should appear as shown
3A.3.i
3A.3.j 3A.3.k
Building Notes:
Slide the belt through the boom
as you slide the boom into the
tail boom mount previously
installed on the frame.
You may have to twist the boom
slightly. Continue to push the
boom forward until the belt
extends out the back of the
boom.
#130-270
#130-275
#130-290
#130-290
Note Slot Orientation
Slide towards rear
of boom for now
Spread the clamp at the
slot to slip over the logo
Insert the end of the tail
rotor belt taped earlier
as shown. Don’t twist
the belt at all
Make sure belt is
straight and not twisted
#130-275
Note Slot
Orientation
