X-Cell Furion 450 Assembly Manual
Created: 8/27/2008
Copyright Miniature Aircraft USA
Page 69 of 89
This document may not be distributed without permission of Miniature Aircraft USA
6A.1.e 6A.1.f 6A.6.g 6A.1.h
Building Notes:
Trim notches in the bottom of
the canopy as shown so that it
will fit flush against the front of
the lower chassis. Insert the two
grommets into the previously
drilled mounting holes.
6A.1.i 6A.1.j 6A.6.k 6A.1.l
Building Notes:
Trim the windshield along the
molded lines using scissors. The
material cuts easily. The finished
shape should look like the
following photo.
Building Notes:
Using a light spray adhesive like
3M 77 or equivalent, spray the
INSIDE of the windshield with
the adhesive. Then apply the
windshield to the canopy as
shown.
The windshield will cover and
hide the previously installed
grommets.
6A.1.m 6A.1.n 6A.6.o 6A.1.p
Building Notes:
Using a #55 (.052”) drill, mark
and drill 6 holes through the
windshield and canopy in the
positions shown. (Two in the
front, and then two on each side
of the windshield)
6A.1.q 6A.1.r 6A.6.s 6A.6.t
Building Notes:
Screw the six self tapping
mounting screws through the
windshield into the canopy.
Lightly tighten them to prevent
“stripping” the plastic in the
canopy.
Building Notes:
Install the canopy by slipping it
over the front of the chassis as
shown
Clean off any adhesive
overspray on the windshield left
from an earlier step
Notch
#130-250
#130-252
Drill #55
#130-024
