X-Cell Furion 450 Assembly Manual
Created: 8/27/2008
Copyright Miniature Aircraft USA
Page 17 of 89
This document may not be distributed without permission of Miniature Aircraft USA
1A.1.i 1A.1.j 1A.1.k 1A.1.l
Building Notes:
Apply a thin coat of green thread
lock on the bearings using a
toothpick. Place a drop of
thread lock on the end of the
toothpick and then smear it
around the bearings. Wipe away
any excess and be careful not to
get any in the bearing
1A.1.m 1A.1.n 1A.1.o 1A.1.p
Building Notes:
Note that each pulley has a
flanged side.
Use an allen driver to push a
bearing into each pulley and
seat against the flange
Set aside allow the thread lock
to dry before installing the
pulleys.
Building Notes:
Do not over tighten bolts. Make
sure pulleys spin freely
Be careful not to get any thread
lock in the bearings.
1A.1.q 1A.1.r
#130-037
#130-052
#130-210
Note
Flange
Inside
#130-052
Use allen driver to
seat bearing against
inside flange in pulley
#130-037
#130-025
