X-Cell Furion 450 Assembly Manual
Page 32 of 89
Copyright Miniature Aircraft USA
Created: 8/27/2008
This document may not be distributed without permission of Miniature Aircraft USA
3A.1.e
3A.1.f 3A.1.g 3A.1.h
Building Notes:
Slide the boom into the
transmission case as shown
until the tail fin stops it at the
rear and then twist as
necessary to align the holes in
the boom with the holes in the
transmission case.
3A.2 – Assemble/Install T/R Bellcrank
3A.2.a
3A.2.b
3A.2.c
3A.2.d
Building Notes:
Press the bearings into the bell
crank as shown. Make sure you
drop the spacer washer between
the bearings.
3A.2.e
3A.2.f
3A.2.g
3A.2.h
3A.2.i 3A.2.j 3A.2.k 3A.2.l
Building Notes:
Before tightening the two bell
crank bracket bolts, make sure
the holes in the transmission
case are aligned with those in
the tail boom. When properly
aligned, these will thread in with
little effort.
#130-340
#130-052
#130-004
#130-052
#130-040
Tighten
snugly
#130-035
#130-010
#130-350
Note
bracket
orientation
Note bellcrank
orientation and
extrusion on bracket
Align slot
in boom
with holes
Slide
boom in
this way
#130-035
#130-355
Holes
Aligned
